Bathtub installation instructions

Preparation of the place

Prepare floor and wall before installing the bathtub. The corner destined for bathtub installation shall be at a right angle, same as the floor in relation to the wall.
All communications on the spot of bath installation shall not obstruct bath legs and the bath itself.
If a bath is equipped with a water faucet, then it is necessary to mount hot and cold water outlets with thread of ½’’ under the bath.

Turn off protective details from the basis of legs (wooden) which are necessary for safe transportation of a bath.
Fasten legs of a bathtub.
Establish draining system.
Measure height of the decorative panel (legs of the decorative panel should be completely twirled).
Arrange baths in the place chosen by you.
Adjust height of a bath so that the height between edges of a bath and the decorative panel was 5 mm (that the panel was freely fixed or removed).
By means of a level, establish a bath.
Facilitate connection of a siphon with sewerage, the sewerage entrance O 50 mm shall be situated on the floor level (or not higher than 5 cm above the floor) and not closer than 20 cm from the bath drainage centre. In case of necessity, use appropriate elbows and elongations.
Establish the decorative panel, having adjusted legs of the panel so that the panel was fixed on edges of a bath.

Clean the bath surface with a soft cloth, use liquid sanitary cleaning aids, if necessary.
Do not use abrasive cleaning aids!
Avoid mechanical damage, such as strong impacts and scratches!
Avoid long contact of a surface of a bath to strongly painting substances!